MPEG LA 4CH Manual de usuario descargar pdf (Pagina 54)

-50-

APPENDIX 1 INSTALL HDD

◎ HDD Installation for Model 1 and 5

Step 1: Loosen the screws on the upper cover and open the upper cover of the DVR

Step 2: Screw out the HDD bracket. For the positions of the HDD bracket screws, please refer to the figure below.

Step 3: Get suitable brand HDD and set the HDD mode (master / slave) according to the indication.

Step 4: Screw HDD onto the HDD bracket, two screws for each side. There are three screw holes per side on the bracket

and you can choose two of them to secure the HDD. And then screw the HDD bracket back to the DVR base.

Step 5: Connect the HDD to the power connector and IDE BUS (make sure to align the HDD precisely for pin connection).

And then close the upper cover of the DVR and fasten all the screws you loosened in the step 1.

◎ HDD Installation for Model 2, 3 and 4

Step 1: Loosen the screws on the upper cover and open the upper cover of the DVR.

Step 2: Screw out the HDD bracket.

Step 3: Get suitable brand HDD and set the HDD mode (master or single).

Step 4: Screw HDD onto the HDD bracket, two screws for each side. And then screw the HDD bracket back to the DVR

base. (Refer to Fig.1 & 2).

Step 5: Connect the HDD to the power connector and IDE BUS (make sure to align the HDD precisely for pin connection)

(Refer to Fig. 3)

Step 6: Close the upper cover of the DVR and fasten all the screws you loosened in the step 1. (Refer to Fig. 4 & 5)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60

Sin comentarios

MPEG LA 4CH Manual de usuario Pagina 54